Screw on LED blade holder for screw together hilt system.
2.5" long with 2" unthreaded.
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
2.5" long with 2" unthreaded.
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
2.5" long with 2" unthreaded
OD at base 1.45"
OD at steps from base 1.2",1.4",1.6",1.74", and 1.9" max OD.
OD at base 1.45"
OD at steps from base 1.2",1.4",1.6",1.74", and 1.9" max OD.
Great
This emitter looks so awesome on my ultrasabers manticore. I love it.
Looks great!
If your going for a Obi-Wan esk build this certainly brings some of the design to your saber. I love it!
nice
i love it. my hilt uses pommel #3v2 and this emitter balances out the look perfectly since its the same dai as the pommel. nice work Tim! 健康多くの寿命 単独で歩く人 (kenkou ooku no jumyou -kage no ranpu-) (health(good) much life(span) -lamp (in the) shadows)
Love It
awesome piece, my first blade holder purchase and was well worth the sacrifice of other BH for this one. i love it thank you so much for all your brilliant machining.
My fave blade holder
this is by far my fave blade holder it is the best looking and works really well - my only complaint s that its to expensive - i think it should be 40 or 45 dollars instead