Screw on LED blade holder for screw together hilt system.
2.5" long with 2" unthreaded.
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
2.5" long with 2" unthreaded.
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Perfect for custom shroud work
I have two of these and they are great for making custom shrouds. In my opinion, these are heavier than certain other blade holders and this helps balance out the hilt.
great!
this product is very good - but to make it look better without spending any more, cut a section of your sink tube off (only a small bit) and cut that in half at an angle stick on the larger piece on the back of the blade holder and it looks like style 10 but cooler