MWS Short Momentary 16mm AV Switch
Pre wired with 2x JST male connectors and a DynaOhm resistor for the LED.
For the MWS Petit Crouton the switch and LED can be plugged into the switch and accent LED connectors.
For the MWS Nano Biscotti the switch will plug into the switch port but the LED currently does not have a matching connector.
Since this is a momentary switch it will not work with the MWS BuckPuck.
Pre wired with 2x JST male connectors and a DynaOhm resistor for the LED.
For the MWS Petit Crouton the switch and LED can be plugged into the switch and accent LED connectors.
For the MWS Nano Biscotti the switch will plug into the switch port but the LED currently does not have a matching connector.
Since this is a momentary switch it will not work with the MWS BuckPuck.
Wiring is too short!
The wiring on this switch is so super short that the components all have to be within a few inches of each other to solder anything together, making it very difficult to handle. Also, the resistor was not strongly connected, it popped out during some of the tugging and pulling as I tried to get everything together