Set of 6 custom formed medium hard black rubber strips.
Includes 3M adhesive tape factory installed for simple peel-and-stick installation.
The tape side is rounded so that it forms to the hilt.
Includes (6) #6-32 button head screws and nuts (all stainless steel).
Includes 3M adhesive tape factory installed for simple peel-and-stick installation.
The tape side is rounded so that it forms to the hilt.
Includes (6) #6-32 button head screws and nuts (all stainless steel).
1/2" wide by 3.6" long and 1/4" tall
Need to make these in hard plastic
Im giving this product a 5 star review because it was not a disapointent.I knew the grips were rubber,as thats how they are advertised and they are good quality.However I would like to see TCSS get hard plastic ones and make them just a tiny bit longer.They are about 1/16" shorter than the graflex 2.0 grips
Perfect for a certain look
Product looks good. A must for any Anakin/Ep4 Luke looking build. Not sure about MHS aluminum parts, but does not stick well to chrome sink tube. The adhesive sticks ok, but any friction will cause it to slide around. I would not recommend using this on sink tube without the screws. I slotted and drilled the other end of mine an used black hex cap screws to secure the other side. Worked great as the cap screws stand up just below the ridge line and both fill the gap as well as blend the color for a less noticeable look. No problems after that. Rubber is easy to cut with a razor knife. If I were doing another, I would start by cutting the other end to secure it as well ahead of time rather than after the fact.