The threads on these are now only .16" long. Which will still work fine with blade holder 20 and other similar setups but will not go through most MHS blade holders enough to lock a blade in place unless there is a counter bore so it can recess down into the part a bit.
Modeled directly from an original Graflex Glass Eye.
Available with a clear or smoked lens.
This 10-32 thumbscrew works nicely as a blade retention screw.
(8)
Average rating 9 out of 10
( based on 8
reviews )

Exactly what I needed
I needed a few parts for a Starkiller saber that was less than accurate. This Graflex Glass Eye Replica Thumbscrew was perfect! Now one step closer to loving my saber. I had to drill out and tap the existing threads to get this to fit but bless you for including the threads 10-32. Saved me the trouble of figuring it out. TCSS ROCKS!!!
Smokey glass eye
Well made. A nice addition to my saber build.
Glass Eye thumbscrew
Looks awesome, now that I've drilled & tapped the saber to fit it. Would & likely will buy again; good stuff.
Glass eye
A nice little greeblie / retention screw that adds a nice accent to any hilt in need of details.
Awesome replacement part
I purchased the smoked glass eye, to replace the one that came with the 2.0 kit. And I have to say, best purchase! The smoke glass eye gives the hilt an authentic look. Very happy with the way it came out!!