MHSV2 Blade Holder Style 4.
Works with all female threaded MHS V2 parts.
*NOT compatible with MHS v1 parts*
Designed to hold any of the 1" OD blades we offer.
You will need to add a blade retention screw hole or purchase that service to hold the blade in.
Adds 2.5" to the length of the saber and is 1.3" OD with the raised section at 1.95" OD.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Works with all female threaded MHS V2 parts.
*NOT compatible with MHS v1 parts*
Designed to hold any of the 1" OD blades we offer.
You will need to add a blade retention screw hole or purchase that service to hold the blade in.
Adds 2.5" to the length of the saber and is 1.3" OD with the raised section at 1.95" OD.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Sleek & Sturdy
Let me just say that I love a good asymmetric design, but for my stunt saber I am trying to build I prefer a clean even look and this blade holder delivers! The small flare out and incised line add just enough style to create an aesthetically pleasing minimalist design without being boring, and the small flare out is a nice design break from handle to blade. I added 4 Drill & Tap Holes for blade retention and after securing the blade and testing some hits I don't feel any wobble at all! I would get this again for a stunt saber or a show saber!