Screw on LED blade holder for screw together hilt system.
2.2" long with 1.7" unthreaded and a max OD of 1.95"
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
2.2" long with 1.7" unthreaded and a max OD of 1.95"
Designed to hold 1" blades.
These do not come pre-drilled for a blade retention screw. We do offer a service to add one in the services section.
All MHS parts should have the threads wiped clean and then lightly oiled or greased. We sell some Synthetic Grease for this. Parts that get stuck because no oil/grease was used or that are damaged by the user trying to take them apart will not be warrantied.
Beautiful blade holder
I have to admit, I wasn't planning on getting this particular blade holder. It was the only one in stock when I bought it, and I needed a complete saber asap. Once I got it, I was so happy that they were out of stock on all the others. It gives my saber just the right look. The blade sits nice and snug in it.
Great Blade Holder design
This blade holder has a very appealing design that really caught my attention. So good, I had to purchase two. This will definitely upgrade any saber build. Note: the grooves are deeper and closer together so using an 8/32 should be used on the lower band for retention screw.