I've primarily used 28mm speakers, and was hesitant when doing my LS6 Gullwing install. I was quite surprised by this speaker's volume. I can't really tell a difference between this and a 28mm. This entire build has been cursed, though, and the solder pads broke, so I had to extend its life for a bit and solder to the wires internally. Didn't last long like this obviously, but it was great while it lasted. Why did I still give it 5 stars? Because factory defects happen, and I'm not going to hold something the company didn't intend on happening against them.
Great little speaker
Review by Hector on 2/24/2018
I have to say for a small 20mm speaker this sucker is pretty loud. I have this speaker in my K4 saber, and you can feel the little vibration it gives off. And also you can hear the swings and clashes very well.
Great Speaker for Tighter Builds
Review by grAfLEX25 on 2/11/2017
I'm impressed with the sound you get out of this small speaker. I would say it's not as loud as the 28 mm Bass Speakers, but it's definitely not quiet. I would not hesitate to use this speaker again in builds where I can't fit the larger 28 mm bass speaker.
A few notes for soldering this speaker: check to see where the speaker wires are attached to the solder pads and solder to the opposite pads (directly across). Look at the speaker from the side and you should see a small wire running to one pad on each side. I didn't realize this the first time and had the speaker wire pop up while trying to solder my wire from my soundboard.
Outstanding sound
Review by Jason on 1/10/2017
These might be the best overall sounding speakers in the shop.
Gaskets peal away.
Review by Denzil on 5/26/2016
Check them carefully before installing. I have had at least 3 of these speakers where the gasket was pealing away from the basket (frame) when they arrived and another 1 where the gasket tore loose completely after a few months of use.
Small, but surprising sound
I've primarily used 28mm speakers, and was hesitant when doing my LS6 Gullwing install. I was quite surprised by this speaker's volume. I can't really tell a difference between this and a 28mm. This entire build has been cursed, though, and the solder pads broke, so I had to extend its life for a bit and solder to the wires internally. Didn't last long like this obviously, but it was great while it lasted. Why did I still give it 5 stars? Because factory defects happen, and I'm not going to hold something the company didn't intend on happening against them.
Great little speaker
I have to say for a small 20mm speaker this sucker is pretty loud. I have this speaker in my K4 saber, and you can feel the little vibration it gives off. And also you can hear the swings and clashes very well.
Great Speaker for Tighter Builds
I'm impressed with the sound you get out of this small speaker. I would say it's not as loud as the 28 mm Bass Speakers, but it's definitely not quiet. I would not hesitate to use this speaker again in builds where I can't fit the larger 28 mm bass speaker. A few notes for soldering this speaker: check to see where the speaker wires are attached to the solder pads and solder to the opposite pads (directly across). Look at the speaker from the side and you should see a small wire running to one pad on each side. I didn't realize this the first time and had the speaker wire pop up while trying to solder my wire from my soundboard.
Outstanding sound
These might be the best overall sounding speakers in the shop.
Gaskets peal away.
Check them carefully before installing. I have had at least 3 of these speakers where the gasket was pealing away from the basket (frame) when they arrived and another 1 where the gasket tore loose completely after a few months of use.